REPLACE SMOKE GENERATOR CONTROL PANEL ASSEMBLY (M1059A3 ONLY)

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-5_562

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
468

TM 9-2350-277-20-5 REPLACE SMOKE GENERATOR CONTROL PANEL ASSEMBLY (M1059A3 ONLY) 0756 00 THIS WORK PACKAGE COVERS: Removal (page 0756 00-1). Installation (page 0756 00-2). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Lockwasher (12) Locknut (4) Personnel Required Unit Mechanic References See your -10 TM 3-1040-283-10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Circuit breaker CB1 OFF (TM 3-1040-283-10) Battery ground strap disconnected (WP 0337 00) WARNING Before you do any maintenance, discharge all capacitors to ground or electrical shock could injure personnel. REMOVAL NOTE Tag all cables to match their respective connectors before removal. 1. Disconnect six cable assembly plugs (1) from control panel (2). Install associated dust caps (3). 2. Remove four screws (4), lockwashers (5), eight washers (6), four locknuts (7), and control panel (2) with two attached brackets (9) and (11) from two brackets (8) and (10). Discard lockwashers and locknuts. 3. Remove eight screws (12), lockwashers (13) and two brackets (9)(11) from control panel (2). Discard lockwashers. 0756 00-1

Privacy Statement
Press Release
Contact