TM 9-2350-277-20-5
REPLACE SMOKE GENERATOR ASSEMBLY AND SUPPORT BRACKET (M1059A3
ONLY) — Continued
0755 00
9.
Remove four screws (2), lockwashers (3), and support bracket (4) from hull top. Discard lockwashers.
INSTALLATION
1.
Position generator support bracket (4) on hull top. Secure with four screws (2) and new lockwashers (3). TIGHTEN
SCREWS TO 54-59 LB-FT (73-80 N m) TORQUE.
2.
Using a suitable lifting device, install smoke generator (1) on armor shield.
3.
Connect glow plug cable (19) to preheat harness jack (20) to panel (21) on smoke generator (1).
4.
Connect fuel supply hose (5) to fuel supply connector (7) and fuel return hose (6) to fuel return connector (8).
5.
Connect fog oil hose (9) to cover assembly connector (10).
6.
Connect air hose (11) to cover assembly connector (12).
7.
Connect electrical cable assembly (13) to cover connector 5J1 (14).
8.
Slide generator (1) onto support bracket (4). Have helper assist.
0755 00-3
