REPLACE SMOKE GENERATOR ASSEMBLY AND SUPPORT BRACKET (M1059A3 ONLY)

REPLACE SMOKE GENERATOR ASSEMBLY AND SUPPORT BRACKET (M1059A3 ONLY) - TM-9-2350-277-20-5_560

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
464

TM 9-2350-277-20-5 REPLACE SMOKE GENERATOR ASSEMBLY AND SUPPORT BRACKET (M1059A3 ONLY) 0755 00 THIS WORK PACKAGE COVERS: Removal (page 0755 00-1). Installation (page 0755 00-3). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Torque Wrench (WP 0926 00, Item 85) Suitable Lifting Device Materials/Parts Locknut (2) Lockwasher (4) Personnel Required Unit Mechanic Helper References See your -10 TM 3-1040-283-10 TM 3-1040-283-20&P Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Circuit breaker CB1 OFF (TM 3-1040-283-10) Battery ground strap disconnected (WP 0337 00) Air pressure released from compressor reservoir (TM 3-1040-283-20&P) Inboard armor shield removed (WP 0771 00) NOTE Before you do any maintenance, discharge all capacitors to ground. REMOVAL 1. Remove two screws (1), four washers (2), two locknuts (3), and wedges (4) from support bracket (5) and generator (6). Discard locknuts. 2. Slide generator (6) out and onto shield. Have helper assist. 3. Disconnect electrical cable assembly (7) from cover assembly connector 5J1 (8). WARNING Compressed air pressure from smoke generator can cause serious injury or death. To avoid accidents, bleed air before working on air compressor assembly or disconnecting any air hose. 4. Disconnect air hose (9) from cover assembly connector (10). 5. Disconnect fog oil hose (11) from cover assembly connector (12). 0755 00-1

Privacy Statement
Press Release
Contact