TM 9-2350-277-20-4
REPLACE LAUNCH TUBE STOWAGE BRACKET (M901A3 ONLY)
0590 00
THIS WORK PACKAGE COVERS:
Removal (page 0590 00-1).
Installation (page 0590 00-2).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Materials/Parts
Cotter pin
Lockwasher (10)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Launch tube removed (see your -10)
REMOVAL
1.
Remove cotter pin (1), headed straight pin (2), strap (3) and upper support (4). Remove strap. Discard cotter pin.
2.
Remove four nuts (5), lockwashers (6), washers (7), screws (8), and washers (9) from upper support (4) and bracket (10).
Remove support from bracket. Discard lockwashers.
3.
Remove two screws (11), lockwashers (12), and washers (13) from bracket (10) and hull (14). Remove bracket. Discard
lockwashers.
4.
Remove pin (15), four screws (16), and washers (17) from lower support (18) and plate (19). Remove lower support.
5.
Remove four screws (20), lockwashers (21), two spacers (22), and two spacers (23) from plate (19) and hull. Remove
plate. Discard lockwashers.
0590 00-1
