TM 9-2350-277-20-4REPLACE FLOOR PLATES (M113A3 AND M577A3 ONLY) — Continued 0539 00INSTALLATION1. If rubber strips (5) removed, apply thin coat of adhesive to roughened side of rubber surface. Allow to dry 20-30minutes. Apply thin coat of adhesive to metal surface of hull crossmembers. Allow to dry 30-120 seconds. Install rubberstrips on crossmembers and press surfaces together firmly.2. Place rear floor plate (4) and two front floor plates (3) on crossmembers. Secure to hull with 16 lined washers (2) andscrews (1).FOLLOW-THROUGH STEPS1. Install personnel heater floor duct, if removed (WP 0706 00).2. Start engine (see your -10).3. Raise and lock ramp (see your -10).4. Stop engine (see your -10).END OF TASK0539 00-2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
