TM 9-2350-277-20-4REPAIR DRIVER’S HATCH (M901A3 AND M981A3 ONLY) — Continued 0538 0011. Move yoke (1) to closed position.12. Place hatch cover (2) into position.NOTEA minimum of one washer (3) and (4) is required between hatch cover (2) and yoke assembly (1).13. Using washers (3) and (4), center latch assembly (5) within stop assembly (6), allowing maximum movement of hatchcover (2) within yoke assembly (1). This allows engagement between latch assembly (5) and stop assembly (6).NOTEApply sealing compound to setscrew (7) before installing.14. Install two washers (3), washers (4), pins (8), snap rings (9), and setscrews (7) on driver’s hatch cover (2).0538 00-17
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business