TM 9-2350-277-20-4REPAIR DRIVER’S HATCH (M901A3 AND M981A3 ONLY) — Continued 0538 0016. Check that yoke support assembly linkage (1) is over center. If linkage is not over center, add shim laminations (2) underbracket (3).17. Push hatch release handle (4) up. Then measure between handle (4) and washer (5). Make sure gap is 0.06 (+0.03, -0.00)inch. If clearance is not within limits, loosen or tighten nut (6), as required.FOLLOW-THROUGH STEPS1. Start engine (see your -10).2. Raise and lock ramp (see your -10).3. Stop engine (see your -10).END OF TASK0538 00-19/20 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business