REPLACE RAMP LOCK LEVER AND CABLE (M577A3 AND M1068A3 ONLY)

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-4_462

TM-9-2350-277-20-4 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
376

TM 9-2350-277-20-4 REPLACE RAMP LOCK LEVER AND CABLE (M577A3 AND M1068A3 ONLY) 0525 00 THIS WORK PACKAGE COVERS: Removal (page 0525 00-1). Cleaning, Inspection, and Repair (page 0525 00-3). Installation (page 0525 00-3). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Cotter pin (2) Key washer (4) Locknut (4) Locknut (2) Lockwasher Spring pin (2) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) REMOVAL 1. Remove two cotter pins (1), headed pins (2), and clevises (3) from arms (4) and (5). Discard cotter pins. 2. Remove two locknuts (6), washers (7), and screws (8) from lever (9). Discard locknuts. 3. Bend back tabs on key washers. Remove four screws (10), key washers (11), and lever assembly (9) from hull top plate. Discard key washers. 4. Remove front support (12), lever (9), key (13), and rear support (12) from arm (4). Remove arm from bulkhead. 5. Remove two spring pins (14), catch (15), and spring (16) from lever (9). Discard spring pins. 0525 00-1

Privacy Statement
Press Release
Contact