TM 9-2350-277-20-4
REPLACE PUSH-PULL CONTROL ASSEMBLY, BRACKET, LINKS, AND PINS
(CABLE-ACTIVATED LOCK) — Continued
0429 00
NOTE
Route push-pull control assembly with one end at transmission controller and other end at
steering wheel housing.
9.
Install push-pull control assembly (7) in clamp (8) and secure to hull with screw (9) and new lockwasher (10).
10. Route push-pull control assembly (7) to transmission controller (11).
11. Remove nut (12) from end of push-pull control assembly (7). Place end of push-pull control assembly (7) through hole
in bracket (13). Install new lockwasher (14) and nut (12).
12. Connect end of push-pull control assembly (7) to bracket (15) with pin (16), two washers (17) and new cotter pin (18).
0429 00-10
