IDLER ARM ASSEMBLY REPAIR (CONTINUED)

IDLER ARM ASSEMBLY REPAIR (CONTINUED) - TM-9-2350-267-34_186

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
157

IDLER ARM ASSEMBLY REPAIR (CONTINUED) lNSPECTION AND REPAIR A B C Inspect housing (20) for damage or defects. Replace if damag- ed or defective. Check ID of inner bearing bore (A). ID (A) of new part is 3.5040-3.5060 inches. Wear limit is. 3.5080 inches. Check ID of outer bearing bore (B). ID (B) of new part is 5.2540-5.2560 inches. Wear limit is 5.2580 inches. D E F G Refer to TM 9-214 for inspection of bearing (5). Check OD (C) of bearing (5). OD (C) of new bearing is 3.4970- 3.4990 inches. Wear limit is 3.4950 inches. Check ID (D) of bearing (5). ID (D) of new bearing is 3.0000- 3.0010 inches. Wear limit is 3.0015 inches. Check fit of bearing (5) in housing. New part fit is 0.0050T- 0.0090L. Wear limit is 0.0135L. TA312560 7-23 Change 1 TM 9-2350-267-34

Privacy Statement
Press Release
Contact