7-8
Change 1
TM 9-2350-267-34
FINAL DRIVE ASSEMBLY REPAIR (CONTINUED)
DISASSEMBLY
A
Remove four screws (1), four lockwashers (2), cover (3) and
gasket (4).
NOTE
If optional seal is used, remove two seals.
B
Remove and discard seal (5).
c
Remove 12 screws (6) and 12 lockwashers (7).
D Remove cover (8) and gasket (9) from housing cover (10).
E
Remove seven screws (11) and seven lockwashers (12).
F
Remove housing cover (10) and gasket (13) from final drive hous-
ing (14).
NOTE
Housing cover and final drive housing are a
matched set. Input splined gearshaft and ring gear
are also a matched set.
G
Remove input splined gearshaft (15) from final drive housing
(14).
H Remove two bearings (16) from input splined gearshaft (15).
TA312553