FINAL DRIVE ASSEMBLY REPAIR (CONTINUED)ABCDEINSPECTION AND REPAIRNOTEFInspect input splined gearshaft (15) for damage or defects. Replace ifdamaged or defective.Housing cover and final drive housing are a matchedset. If either is defective, replace both.GInspect input splined gearshaft (15) for broken or missing splines and gearteeth. Replace if splines or gear teeth are missing or broken.Inspect housing cover (10) for cracks. Repair or replace as matched set ifHInspect output shaft (21) for damage or defects, and for broken or missingcracked.splines on both ends of shaft. Replace if splines are broken or missing.Inspect housing cover (10) for stripped threads. Retap stripped threads.NOTECheck find drive housing (14) for cracks or damage. Replace as matchedInput splined shaft and ring gear are a matched set.set if defective.If either is defective, replace both.Refer to TM 9-214 for inspection of bearing races in place.IInspect ring gear (19) for broken or missing teeth. Replace as matched setRefer to TM 9-214 for inspection of bearings (16).if teeth are broken or missing.JCheck spacer (20) for cracks or distortion. Replace if defective.NOTEK Refer to TM 9-214 for inspection of bearings (22 and 28).Input splined gearshaft and ring gear are a matchedset. If either is defective, replace both.TA3125567-11Change 1TM 9-2350-267-34
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business