7-38
TM 9-2350-267-20
TRANSMISSION INTERNAL BRAKE: ADJUSTMENT
ADJUSTMENT
A
B
C
NOTE
If brake linkage is not installed, brakes maybe ad-
justed using same procedure as outlined, except
that special wrenches for brake adjustment may
be used to apply brakes. Brakes should be applied
to approximately 90 Lb-ft.
Check brake linkage adjustment.
Apply brakes fully and watch index marks (1) on
brake levers (2). If index marks (1) rotate to AP-
PLY mark (3) on retainer (4), but not to RE-
ADJUST mark (5), brakes are not properly
adjusted. If index marks (1) do not rotate to APP-
LY mark (3) or rotate past readjust mark (5),
brakes must be readjusted.
Remove 12 screws (7), 12 washers (8) and two transmission
covers (9).
Adjust by rotating two nuts (10) counterclockwise to tighten
and clockwise to loosen, using screwdriver (11).
Apply two brakes uniformly using brake adjust wrenches (6).
TA310128
