7-42
Change 2
TM 9-2350-267-20
PARKING BRAKE LINKAGE: ADJUSTMENT
ADJUSTMENT
A
B
C
D
E
F
G
H
Unlock (up position) parking brake handle (1).
Remove two screws (2) and two lockwashers (3) to loosen
bracket (4). Discard lockwashers.
Loosen two locknuts (5) at forward and rear brake control rods
(6 and 7).
Turn connecting nut (8) in either direction until bracket screw
holes (4) line up with mating holes (not shown), and no pressure
is on bell crank (9) to dine holes.
Install two screws (2) and two new lockwashers (3) to secure
bracket (4) to bulkhead.
Tighten two locknuts (5) on forward and rear brake control rods
(6 and 7).
Depress service brake pedal (10) and pull back parking brake
handle (1).
Release service brake pedal (10).
NOTE
Parking brakes should stay locked. If not,
readjust.
TA57232