TRANSMISSION THROTTLE VALVE: ADJUSTMENT
ADJUSTMENT
NOTE
Perform engine throttle governor control rod adjustment
(p 7-46).
A Remove lockpin (1), clevis pin (2) and transmission throttle valve control
rod (4) from throttle control lever bracket (3). Discard lockpin.
B Hold accelerator pedal in depressed position (p 7-47).
C Move transmission throttle valve control rod (4) against stop (towards
drivers bulkhead).
D Loosen nut (6).
E Turn transmission throttle valve control rod ends (7) until pin (2) enters rod
end and lever bracket freely. Turn 1/2 turn at a time.
F
Release accelerator pedal (p 7-47).
G Rotate transmission throttle valve control rod end (7) two turns clockwise.
Lengthen rod (4) and compress spring (5).
H Tighten nut (6).
I
Install transmission throttle valve control rod (4), clevis pin (2) and new
lockpin (1) on bracket (3).
7-43
Change 4
TM 9-2350-267-20