BRAKE ASSEMBLY IN DRIVERS COMPARTMENT: REMOVAL, DISASSEMBLY, ASSEMBLY, INSTALLATION AND ADJUSTMENT
INITIAL SETUP
Equipment condition:
Vehicle tracks blocked.
REMOVAL
A Open transmission access doors.
B
Remove cotter pin (1) and straight pin (2) from pull lever (3).
Discard cotter pin.
C
Remove screw (4), flat washer (5) and pull lever (3) from shaft (6).
D
Remove and discard lockwire (7).
E Unscrew retainer plate (8) from end of support (9) and remove
seal (10). Discard seal.
F
Remove screw (11) and lockwasher (12) from parking brake (13).
Discard lockwasher.
G Disconnect two electrical connectors (14) at brake warning light
switch.
H Remove four screws (15), four lockwashers (16) and four flat
washers (17) at drivers bulkhead. Discard lockwashers.
NOTE
Note number and location of shims to ensure pro-
per installation.
I
Remove brake assembly (18) and shims (19) from drivers
compartment.
TA57214
7-15
Change 2
TM 9-2350-267-20