7-14.4
Change 4
TM 9-2350-267-20
STEERING CONTROL LINKAGE: INSTALLATION (CONTINUED)
G
Position steering shaft assembly (12) with two brackets (7 and 11), and
spacer (13) in driver’s compartment.
H
I
J
K
L
M
Instal lbracket (1l) and spacer (13) using four screws (8), four new lockwasbers
(9) and four flat washers (10).
Install bracket (7) using four screws (5) and four new lockwashers (6).
NOTE
Rod assembly (4) is connected between steering shaft
and bulkhead-mounted housing.
Install rod assembly (4) using two new cotter pins (l), two flat washers (2)
and two pins (3).
Install master warning light assembly on steering shaft mount (p 7-53).
Adjust steering control linkage (p 7-44).
Close transmission access doors.
