STEERING SHAFT ASSEMBLY: ASSEMBLY (CONTINUED)D Install bracket (11) on shaft (36) using two new retaining rings (43) andbearing (44).E Install master warning light bracket (42) on bracket (11) using three screws(40) and three new lockwashers (41).F Install sleeve (37), spring (38) and washer (39) on shaft (36).G Install steering wheel (35) on shaft (36) using new cotter pin (32), flat washers(33), and pill (34).STEERING CONTROL LINKAGE: INSTALLATIONINSTALLATIONABCDEFGInstall rod (30) through bulkhead with clamped end of boot first.Install cover (23) using two screws (21) and washers (22).Install housing assembly at bulkhead with three screws (18) and newlockwashers (19).Connect pin (15) with chain (14) and wire to lever (17).Connect rod (30) to lever (17) using pin (15) with chain (14).Install lever (28) and snap ring (27).NOTEWhen installing shaft center line of shaft rod lever mustbe in line with transmission shaft pointer.Connect rod (30) to lever (28) using pin (24) and chain (29).7-14-3Change 4TM 9-2350-267-20
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
