STACKER FOOT BRAKE: REMOVAL, DISASSEMBLY, ASSEMBLY, INSTALLATION AND ADJUSTMENT

IDLER SPROCKET ASSEMBLY: REMOVAL AND INSTALLATION

STACKER FOOT BRAKE: REMOVAL, DISASSEMBLY, ASSEMBLY, INSTALLATION AND ADJUSTMENT (cont) - TM-9-2350-267-20_1133

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
1043

I 12-40 Change 2 TM 9-2350-267-20 STACKER FOOT BRAKE: REMOVAL, DISASSEMBLY, ASSEMBLY, INSTALLATION AND ADJUSTMENT REMOVAL A Remove spring (1) from brake arm (2) and brake pedal (3). B Remove screw (4), flat washer (5), and brake arm (2) from pivot block (6). C Remove screw (7), flat washer (8) and brake pedal (3) from idler sprocket support (9). D Remove two screws (10), two flat washers (11), and two lockwashers (12) that secure pivot block (6) and shim (13) to idler sprocket support (9). Discard lockwashers. E Remove spring pin (14) using punch and hammer. Discard spring pin. DISASSEMBLY A Remove pedal assembly bearing (15) from brake pedal (3), and arm assembly bearing (16) from brake arm (2). NOTE Record number and location of flat washers used to shim rack base to ensure proper installation. B Remove two screws (17), two flat washers (18), two lockwashers (19), shims (20) (if applicable) and brake pad (21) from brake arm (2). Discard lockwashers. C Remove screw (22), flat washer (23), lockwasher (24), and ad- justing block (25) from brake arm (2). Discard lockwasher. D Remove two adjusting screws (26) from brake arm (2). I a TA57480

Privacy Statement
Press Release
Contact