STACKER FOOT BRAKE: REMOVAL, DISASSEMBLY, ASSEMBLY, INSTALLATION AND ADJUSTMENT (cont)

STACKER FOOT BRAKE: REMOVAL, DISASSEMBLY, ASSEMBLY, INSTALLATION AND ADJUSTMENT (cont) - TM-9-2350-267-20_1133

STACKER WEAR STRIP: REMOVAL AND INSTALLATION

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
1045

12-40.2 Change 2 TM 9-2350-267-20 STACKER FOOT BRAKE: REMOVAL, DISASSEMBLY, ASSEMBLY, INSTALLATION AND ADJUSTMENT (CONTINUED) D Install brake arm (2) on pivot block (6) and secure with screw (4) and flat washer (5). E Install spring (1) on brake arm (2) and brake pedal (3). ADJUSTMENT A Back off screw (22) enough to allow free play in adjusting block (25). . It may be necessary to use longer adjusting screws and more shims. Adjusting screws should be turned equally so adjusting block will not be cocked in brake arm. l Turning two adjusting screws clockwise will decrease travel of brake pad to wear strip. B Turn two adjusting screws (26) to position adjusting block (25) to hold stacker when brake pedal (3) is depressed. C After proper adjustment is achieved, secure adjusting block (25) to brake arm (2) by tightening screw (22). TA57482

Privacy Statement
Press Release
Contact