12-38
TM 9-2350-267-20
CARRIER ASSEMBLY: DISASSEMBLY AND ASSEMBLY
DISASSEMBLY
A Remove two outer bearing support retainer assemblies (1) from
carrier assembly (2) by removing from each, two nuts (3) and
two lockwashers (4) from two studs (5).
B
Remove two inner bearing support retainer assemblies (6) from
carrier assembly (2) by removing from each, two screws (7) and
two lockwashers (8).
C Remove from each retainer assembly, two roller bearings (9) and
two shafts (10).
D Remove from both outer retainer assemblies (1), two adjusting
screws (11) and two jam nuts (12).
E
Remove from one outer retainer assembly (1), cable attach-
ment (13).
ASSEMBLY
A At installation, loosen two nuts (3) and adjust two setscrews
(11) in each of two outer roller bearing retainers (1) to allow
smooth, but firm up/down travel of carrier assembly (2). After
adjustment, tighten two nuts (3) to secure each of two roller
bearing retainers on carrier (2). Secure four setscrews (11) with
four jam nuts (12).
B Reverse disassembly procedures.
TA310238
