STACKER ASSEMBLY
zz
12-30.4
Change 4
TM 9-2350-267-20
A
B
c
D
E
F
G
H
I
J
K
L
Install stacker/crane lifting device (29) in lifting eye on top of roller support (30)
and lift stacker assembly (35) into vehicle.
Slide upper crossmember (34) through stacker roller support (30).
NOTE
Step C applies to vehicles 471 and above.
Install screw (36), plate (38), washer (37), and new locknut (39) on stacker
crossmember (34).
Install upper crossmember supports (33) on upper crossmember (34).
Secure two upper crossmember supports (33) to vehicle ceiling with eight
screws (31) and eight new lockwashers (32).
Remove lifting device from clevis (28) and remove stacker/crane lifting device
(29) from lifting eye on top of roller support (30).
Remove clevis (28) from stacker/krane lifting device (29).
Close and secure vehicle top doors (TM 9-2350-267-10).
Connect bar assembly (26) to stacker motor support bracket (24) with quick-
disconnect pin (27).
Install tee assembly (21) on stacker motor support bracket (24) and secure with
nut (25).
Install tee assembly (22) on stacker motor support bracket (24) and secure with
nuts (23).
Install reducer assemblies (19 and 20) on tee assemblies (21 and 22).
M Install hoses (5 and 6) on reducer assemblies (19 and 20).
