STACKER ASSEMBLY REMOVAL AND INSTALLATION (CONTINUED)

STACKER ASSEMBLY: REMOVAL AND INSTALLATION (CONTINUED)

STACKER ASSEMBLY REMOVAL AND INSTALLATION (CONTINUED) - TM-9-2350-267-20_1116

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
1027

CAUTION STACKER ASSEMBLY REMOVAL AND INSTALLATION (CONTINUED) 0 P Open and secure vehicle top doors (TM 9-2350-267-10). Secure clevis (28) to stacker/crane lifting device (29). Q R S T U V NOTE After attaching suitable lifting device to clevis, pay in cable to take slack out. Lifting device must support stacker and upper crossmember assembly. Attach stacker/crane lifting device (29) to lifting eye on top of roller support (30). Attach suitable lifting device to clevis (28). Remove eight screws (31) and eight lockwashers (32) that secure two upper crossmember supports (33) to vehicle ceiling. Discard lockwashers. Remove upper crossmember supports (33) from upper crossmember (34). NOTE Step T applies to vehicles 471 and above. Remove screw (36), plate (38), washer (37), and locknut (39) from upper crossmember (34). Discard locknut. Slide upper crossmember (34) out of stacker roller support (30). Lift stacker assembly (35) from vehicle and remove stacker/crane lifting device (29) from lifting eye on top of roller support (30). 12-30.3 Change 4 TM 9-2350-267-20

Privacy Statement
Press Release
Contact