DEAD-END SECTION ASSEMBLY: REMOVAL, DISASSEMBLY AND INSTALLATION (CONTINUED)
DISASSEMBLY
A Remove two set screws (5) that secure flipper block (6) to support bar (7).
B
Remove two cotter pins (8) and two flat washers (9) and drive out support bar
(7). Remove flipper block (6) from dead-end section (1). Discard cotter pins.
C Remove three screws (10) from bottom wear strip (11). Pry strip (11) from
surface of dead-end section (1). Discard screws and wear strip.
D Remove 20 screws (12) from wear strips (13 and 14). Pry wear strips (13 and
14) from surface of dead-end section (1). Discard screws and wear strips.
12-13
Change 4
TM 9-2350-267-20