OPERATING THE APU - Continued - TM-9-2350-267-10

OPERATING THE APU - Continued - TM-9-2350-267-10_158

OPERATING THE APU - Continued - TM-9-2350-267-10_160

TM-9-2350-267-10 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
145

TM 9-2350-267-10 OPERATING THE APU - Continued 9. 10. 11. 12. Continue charging batteries until charge indicator in supported vehicle reads well into normal range. Turn APU GENerator switch (6) OFF, and turn APU FUEL SHUT OFF switch (7) OFF to shutdown APU. WARNING To avoid injury, turn MASTER switches in both vehicles OFF be- fore disconnecting slave cable. Turn OFF MASTER switch in each vehicle. Disconnect and stow slave cable. Charging Dead Batteries with APU NOTE This procedure applies only to vehicles with dead batter- ies. If any lights or gages function when a vehicle’s MAS- TER switch is ON, batteries are low, not dead. To charge low batteries see page 2-123. 1. Before trying to charge batteries, do the following: a. Check batteries for broken case, broken cables, severe corrosion and other damage. Notify Organizational Maintenance if batteries are badly damaged. b. Check electrolyte level (TM 9-6140-200-14). Notify Organizational Maintenance if electrolyte is not at proper level. 2-125

Privacy Statement
Press Release
Contact