TM 9-2350-261-34
N O T E
All dimensions shown in the following
illustration are in inches and metric
equivalents. Dimension tolerances are ±
1/16 inch (2 mm), unless otherwise
indicated.
9. Locate, drill, and thread mounting holes as
explained in following illustration and text.
10. Place ramp nonskid plate on ramp to use
as a template to locate five holes. Drill five
holes with 27/64 inch (11 mm) drill. Tap
holes 1/2-13 UNC-2B to at least 1 inch
(3 cm) deep. Use screw threading set.
11. Place ramp door non-skid plate on ramp
door to use as a template to locate four
holes. Drill four holes with 27/64 inch
(11 mm) drill. Tap holes 1/2-13 UNC-2B
at least 1 inch (3 cm) deep. Use screw
threading set.
12. Place new handle stop and new release
bracket on ramp to use as template to
locate five holes. Drill five holes with
5/16 inch (8 mm) drill. Tap holes 3/8-16
UNC-2B to at least 1 inch (3 cm) deep.
Use screw threading set.
16-2