INSTALL - TM-9-2350-261-34

C H A P T E R 17 M A I N T E N A N C E O F C A P S T A N A N D A N C H O R K I T S

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
412

TM 9-2350-261-34 INSTALL 13. 14. 15. 16. 17. 18. Place bracket spacer (1) and release bracket (2) on ramp (3). Secure with three key washers (4) and screws (5). 19. Place handle release (6) with one washer (7) on each side in release bracket (2). Secure with spring pin (8). 20. Place stop spacer (9) and handle stop (10) on ramp (3). Secure with two key washers (11) and screws (12). 21. Place ramp non-skid plate (13) on ramp (3). Secure with five key washers (14) and 22. screws (15). Place ramp door non-skid plate (16) on ramp door (17). Secure with four key washers (18) and screws (19). Bend one tab of each key washer (4, 11, 14, and 18) up against flat of each screw (5, 12, 15, and 19). Insert outer handle (20) in ramp with at least one shim (21). Install at least one shim (21), key (22), inner handle (23), and nut (24) on handle (20). Turn handle (23) to lock ramp door. Then, raise ramp (see your –10). Open and close door, checking door action and handle end play. Adjust per step 22. Add or remove shims (21) on either side of ramp, as needed, to keep ramp door flush with outside of ramp. Ramp door must be within 1/32 inch (2 mm) with outside of ramp. There must be no handle end play. FOLLOW-THROUGH STEPS 1. Raise and lock ramp (see your –10). 3. Stop engine (see your –10). 2. Remove wood blocks from ramp area. END OF TASK 16-3 (16-4 blank)

Privacy Statement
Press Release
Contact