REPAIR (cont) - TM-9-2350-261-34

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
406

TM 9-2350-261-34 N O T E A hole or tear in the tent more than 4-3/4 inches (12 cm) in diameter or length may be repaired by a cement patch. The tear must not occur on seams, edges, or areas that support hardware. The materials used to make a cement patch are adhesive, round patches, roller, board, wire brush, and soft bristled brush. For cement patch repair, do steps 13 thru 20. 13. 14. 15. Select one of three sizes of patches that will overlap damaged area with a margin of at least 3/4 inch (19 cm) on all sides. Place board under damaged area for a flat working surface. Buff patch and damaged area of tent with a wire brush. W A R N I NG Adhesive is flammable and can injure you. Keep it away from heat, sparks, and open flame. Avoid re- peated or prolonged breath- ing of vapors. Avoid contact with your skin. 16. 17. 18. 19. 20. Center patch over damaged area. Apply adhesive to patch and patch edge with a soft bristle brush, making a circle on tent. Lift patch. Apply adhesive to area of tent inside adhesive circle. Allow adhesive to dry until tacky. Press cement surfaces together firmly with roller while tacky. Seal by wiping edge of patch with soft bristle brush. 15-3 G O T O N E X T P A G E

Privacy Statement
Press Release
Contact