REMOVE

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
396

TM 9-2350-261-34 5. 6. Use multimeter to check diode. Set meter to above 200 mV scale. Place probes on each end of diode. Switch probes. Multimeter reading will be infinity or resistance in either position. One position must read infinity and the other resistance and vice versa for diode to operates properly. Use multimeter to check motor resistor. Place probes on resistor leads. Multimeter should read 0 ohms resistance. Replace resistor if reading is infinity. INSTALL 7. Install motor resistor (1) on bracket (2) with screw (3) and nut (4). 8. Secure motor resistor (1) leads to terminals No. 4 and No. 6 of terminal board (5). 9. Install diode (6) in holder (7). 10. Install guard (8) on heater (9). Secure with four screws (10). FOLLOW-THROUGH STEPS 1. Install engine coolant heater in carrier (see your -20). END OF TASK 14-59

Privacy Statement
Press Release
Contact