REPLACE FIXED RESISTOR

CLEAN, INSPECT, AND REPLACE - TM-9-2350-261-34_416

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
392

TM 9-2350-261-34 REPLACE FIXED RESISTOR DESCRIPTION This task covers: Remove (page 14-55). Install (page 14-56). INITIAL SETUP Tools: References: Automotive Fuel and Electrical System Repair See your -20 Tool Kit (Item 7, App B) Digital Multimeter (Item 62, App B) Equipment Conditions: Wrench Kit (Item 106, App B) Engine coolant heater removed from carrier Materials/Parts: Sleeve Personnel Required: Fuel and Elec Sys Rep 63G10 (see your -20) Fuel control valve removed from coolant heater (page 14-48) REMOVE 1. 2. 3. 4. 5. 6. 7. Remove two screws (1) and fuel control valve bracket (2) from coolant heater (3). Loosen four nuts (4), and remove end cover (5) from heater (3). Remove two screws (6) that secure tapping plate (7), flange (8), and fuel tube (9) to heater (3). Remove nut (10), fixed resistor (11), flange (8), fuel tube (9), and sleeve (12) from heater (3). Remove nut (13), screw (14), and electrical lead (15) from freed resistor (11). Use multimeter. Check resistance from circuit 7 terminal end (16) to strap end (17) of freed resistor (11). Multimeter should read 1.6 to 1.7 ohms. If reading is not in range, replace fixed resistor. GO TO NEXT PAGE 14-55

Privacy Statement
Press Release
Contact