REPLACE BURNER PACKING AND GASKET

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
394

TM 9-2350-261-34 REPLACE BURNER PACKING AND GASKET INITIAL SETUP Tools: References: Automotive Fuel and Electrical System Repair See your -20 Tool Kit (Item 7, App B) Wrench Kit (Item 106, App B) Equipment Conditions: Engine coolant heater removed from carrier Materials/Parts: (see your –20) Gasket Fixed resistor removed from heater (page Preformed packing 14-55) Fuel control valve removed from heater (page Personnel Required: 14-48) Fuel and Elec Sys Rep 63G10 REMOVE 1. 2. 3. Remove screw (1), washer (2) and ground strap (3) from burner assembly (4). Remove four nuts (5), bolts (6), clamps (7), and burner (4) from heater (8). Remove preformed packing (9) and gasket (10) from burner (4). Discard preformed packing and gasket. INSTALL 4. 5. 6. Install new preformed packing (9) and new gasket (10) in groove of burner (4). Place burner (4) in heater (8). Secure with four nuts (5), bolts (6), and clamps (7). Install ground strap (3) on burner (4). Secure with screw (1) and washer (2). FOLLOW-THROUGH STEPS 1. Install fixed resistor on heater (page 14-55). 3. Install engine coolant heater in carrier (see your -20). 2. Install fuel control valve on heater (page 14-48). END OF TASK 14-57

Privacy Statement
Press Release
Contact