TM 9-2350-261-34
REPLACE DIODE AND MOTOR RESISTOR
DESCRIPTION
This task covers:
Remove (page 14-58).
Install (page 14-59).
INITIAL SETUP
Tools:
References:
Automotive Fuel and Electrical System Repair
See your -20
Tool Kit (Item 7, App B)
Digital Multimeter (Item 62, App B)
Equipment Conditions:
Wrench Kit (Item 106, App B)
Engine coolant heater removed from carrier
Personnel Required:
Fuel and Elec Sys Rep 63G10
(see your -20)
REMOVE
N O T E
Note direction of arrow on diode so it can
1. Remove four screws (1) and guard (2) from
be installed later.
heater (3).
2.
3.
4.
Remove diode (4) from holder (5).
Remove motor resistor (6) leads from
terminals No. 4 and No. 6 on terminal
board (7).
Remove nut (8), screw (9), and motor resistor
(6) from bracket (10).
14-58
