TM 9-2350-261-34INSTALL PERSONNEL HEATER KIT (M113A2, M741A1, AND M1059 ONLY) INITIAL SETUP Tools:General Mechanics Tool Kit (Item 35, App B)Materials/PartsDry cleaning solvent (Item 18, App C)Sealing compound (Item 70, App C)Sealing compound primer (Item 74, App C)Kit P/N 12349702 (19207)Personnel Required:Track Vehicle Repairer 63H10References:See your -10See your -20Equipment Conditions:Ramp lowered (see your -10)Engine stopped (see your -10)Carrier blocked (see your –10)Battery ground lead disconnected(see your -20)Power plant rear access panel removed(see your -20)Floor plates removed (see your -20)Fuel compartment drained (see your –20)INSTALL1.2.3.4.5.NOTEFuel hoses used on the personnel heaterinstallation are the flareless type. If it isnecessary to replace hose, the connectionfittings must also be replaced.Remove six screws (l), two cover plates (2),and two gaskets (3) from top of carrier.Discard cover plates and gaskets.Remove nut (4) and screw (5) fromtransverse beam. Discard nut and screw.Remove nut (6) and screw (7) from enginecompartment bulkhead. Discard nut andscrew.Remove four nuts (8) and screws (9) fromengine compartment bulkhead. Retain fournuts and screws.Remove four nuts (10), screws (11),cover (12) and gasket (13) from enginecompartment bulkhead. Retain four nuts.Discard screws, cover, and gasket.6. Remove two nuts (14), screws (15),retainer (16), cover (17), and gasket (18)from engine compartment bulkhead. Discard11-2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business