REPLACE RAMP HYDRAULIC CYLINDER ANCHOR
(M106A2, M1064, AND M125A2 ONLY)
DESCRIPTION
This task covers:
Remove (page 10-6).
Modify (page 10-7).
Install (page 10-8).
INITIAL SETUP
Tools:
General Mechanics Tool Kit (Item 35, App B)
Torque Wrench (Item 112, App B)
Electrical Disc Sander (Item 76, App B)
Pneumatic Hammer (Item 40, App B)
Portable Electric Drill (Item 23, App B)
Twist Drill, 7/16 (Item 25, App B)
Materials/Parts:
Primer paint (Item 74, App C)
Anchor
Cotter pin
Screw
Washer
Screw
Materials/Parts (cont):
Personnel Required:
Track Vehicle Repairer
References:
See your -10
See your -20
TM 9-1015-232-35
TM 43-0139
Equipment Conditions:
63H10
Engine stopped (see your –10)
Carrier blocked (see your -10)
Ramp lowered (see your -10)
Mortar removed (see your -10)
Mortar turntable and ring gear removed
(TM 9-1015-232-35)
REMOVE
3.
1. Remove cotter pin (1). Discard pin.
4.
2. Remove headed pin (2). Retain pin.
Remove cylinder (3) from anchor (4).
Remove anchor (4) and all weld material
from hull bottom plate. Discard anchor (4).
Use pneumatic hammer.
10-6
Change 2
T M 9 - 2 3 5 0 - 2 6 1 - 3 4
