27. Remove two screws (1), washers (2), tow
28.
29.
30.
start control lever (3), and mounting bracket
(4) from transmission.
Remove four screws (5), washers (6), and
wiring harness brackets (7) from
transmission.
Disconnect front connector (8) and rear
connector (9) on transmission and remove
transmission wiring harness (10).
Remove six screws (11), washers (12), and
TM 9-2350-261-34
I N S T A L L
31. Remove transmission from shipping
32,
end cover (13) from right rear of
transmission.
33.
34.
container (see TM 9-2520-272-34 & P). Set
transmission on two blocks (14).
Install end cover (13) and secure with six
screws (11) and washers (12) on
transmission. Tighten six screws to
156-180 in-lb (18-20 N·m) torque.
Install two variable speed clutch hose clamp
brackets (15) on transmission. Secure with
two screws (16) and washers (17).
Mount two variable speed hose clamps (18)
on brackets (15) with- two screws (19),
washers (20), and new locknuts (21).
GO TO NEXT PAGE
8-7
