TM 9-2350-261-34
75.
76.
77.
Install harness (1) through drivers compart-
ment bulkhead opening. Connect connector
(2) to dimmer switch (3).
Secure cover (4) to four new locknuts (5) in
bulkhead with four screws (6).
Install harness (1) on two weldnuts (7). Se-
cure with two clamps (8), washers (9), and
screws ( 10).
78.
79.
Install harness (1) on three cradles ( 11). Se-
cure with three cradle clips (12).
Connect circuit 75A and 75B leads (13 and
14) to stop light switch (15) inside power
plant compartment.
80. Connect circuit 452 lead (16) to front bilge
pump (17).
GO TO NEXT PAGE