R E S E AL

R E S E A L F U E L C O M P A R T M E N T W E L D J O I N T S ( M 1 2 5 A 2 , M 1 0 6 A 2 , A N D M 7 4 1 A 1 O N L Y)

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
148

TM 9-2350-261-34 R E S E AL CAUTION D o n o t a p p ly sealing compound in temperatures under 45°F (7°C). Compound will not set at low temper- 5. 6, ature. Apply a layer of sealing compound 1/8-1/4 inch (3-6 mm) thick. Extend seal about 1 inch (3cm) on both sides of weld joint centerlines. While sealing compound is still tacky, lay a new rubber seal 60–1/2 inches (154 cm) long over centerline of inside and outside of sponson–to-fuel compartment weld joint. Run seal full length of weld joint around inside and outside bottom of fuel compartment. 7. ⁸-. 9. 10. Lay a new rubber seal 66–1/2 inches 169 cm) long over centerline of inside and outside of hull roof–to-fuel compartment weld joint. Run seal full length of weld joint around top of fuel compartment. Lay a new rubber seal 31/-3/4 inches 82 cm long over centerline of weld joint at rear of fuel compartment inside fuel tank. Trim seal, as needed, to butt against seals at top and bottom of fuel compartment. Lay a new rubber seal 31–3/4 inches (82 cm) long over centerline of inside and outside of left hull plate-to--fuel compartment weld joint. GO TO NEXT PAGE 4-7

Privacy Statement
Press Release
Contact