B L O C K P O W E R P L A N T (cont)

R E M O V E / I N S T A L L T R A N S M I S S I O N

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
91

TM 9-2350-261-34 4. Stack a 4 x 6 x 10 inch (10 x 15 x 25 cm) 6. Lower power plant slowly down onto blocks. block (1), a 2 x 4 x 10 inch (5 x 10 x 25 Check that power plant is firmly supported cm) block (2), and a 1 x 4 x 10 inch (3 x 10 by the blocks. x 25 cm) block (3) under transmission side of transfer gearcase. Blocks should be 8 inches 7. Cover air inlet housing (6). Use wiping rag. (20 cm) high. 5. Stack a 4 x 6 x 18 inch (10 x 15 x 46 cm) block (4) and a 2 x 4 x 18 inch (5 x 10 x 46 cm) block (5) under rear of engine. Blocks should be about 7 inches (16 cm) high. FOLLOW-THROUGH STEPS 1. Install power plant in carrier (see your -20). END OF TASK 3-3

Privacy Statement
Press Release
Contact