B L O C K P O W E R P L A N T

C H A P T E R 3 M A I N T E N A N C E O F P O W E R P L A N T

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
90

TM9-2350-261-34 B L O C K P O W E R P L A N T INITIAL SETUP Tools: Lifting Sling (Item 84. App B) Materials/Parts: Personnel Required: All blocks are made from surfaced dimensioned Track Vehicle lumber. Dimensions are in inches with metric Helper (H) equivalents. References: Lumber 4 x 6 x 18 (10 x 15 x 46 cm) (5) See your –20 Lumber 4 x 6 x 10 (10 x 15 x 25 cm) Repairer 63H10 Equipment Conditions: Lumber 2 x 4 x 10 ( 5 x 10 x 25 cm) Power plant removed from carrier Lumber 1 x 4 x 10 ( 3 x 10 x 25 cm) (see your –20) Wiping rag (Item 86, App C) BLOCK POWER PLANT 1. disassembly. W A R N I N G You could get hurt if power plant is not blocked to prevent sudden movement of a component. Block p o w e r p l a n t a s s h o wn before you attempt any W A R N I N G Hanging loads could kill or injure you. Keep away horn hanging loads and over- head equipment. Keep hands out of engine compartment while power unit is being removed or installed. Use a lifting device of at least 2,500 lb (1, 135 kg) capacity and sling to lift power plant. Have helper (H) assist. 2. 3. On level ground, place two 4 x 6 x 18 inch (10 x 15 x 46 cm) blocks (1) under front of engine. Place blocks parallel to each other with 6 inch side down. Blocks should be about 18 inches (46 cm) apart from outside edges. Stack two 4 x 6 x 18 inch (10 x 15 x 46 cm) blocks (2) on top of each other. Place blocks (2) on top of blocks (1) at a 90 degree angle. Blocks will be about 10 1/2 inches (24 cm) high. 3-2 Lumber 2 x 4 x 18 ( 5 x 10 x 46 cm)

Privacy Statement
Press Release
Contact