TM 9-2350-261-20-4
REPLACE SMOKE GENERATOR GLOW PLUG CABLE ASSEMBLIES
0714 00
(M1059 ONLY) -- Continued
1.
Disconnect interior cable (1) from jack 1J6 (2) on back of control panel (3).
NOTE
There are seven clamps that bolt interior cable to hull. One is used on the right side of carrier
and six on the left. All are removed the same way. Only one clamp is shown. Remove as
required.
Remove six screws (1), lockwashers (2), clamps (3), and interior cable (4) from left side of hull. Discard lockwashers.
2.
NOTE
There are two exterior cables, access plates, and smoke generators, left and right. Cables are
removed from carrier the same way. Only one exterior cable, access plate, and smoke generator
is shown. Remove cables as required.
3.
Disconnect exterior cable (5) from interior cable (4) in left access plate (6).
4.
Disconnect exterior cable (5) from preheat harness jack (7) on panel (8) of left smoke generator (9).
5.
Remove screw (1), lockwasher (2), clamp (3), and interior cable (4) from right side of hull. Discard lockwasher.
6.
Disconnect exterior cable (5) from interior cable (4) in right access plate (6).
7.
Disconnect exterior cable (5) from preheat harness jack (7) on panel (8) of right smoke generator (9).
8.
Remove four screws (10), locknuts (11), and interior cable (4) from right access plate (6). Discard locknuts.
Remove four screws (10), locknuts (11), and interior cable (4) from left access plate (6). Discard locknuts.
9.
0714 00-2