INSTALL - TM-9-2350-261-20-2

R E P L A C E F U E L S H U T O F F C A B LE

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
519

TM 9-2350-261-20-2 INSTALL 8. Install new grommet (1) in driver’s floor 9. 10. 11. plate. Feed cable assembly (2) through mounting hole in driver’s compartment bulkhead to power plant front access door opening. Slide washer (3) and nut (4) on cable assembly (2). Secure to driver’s compartment bulkhead. Install cable assembly (2) on two weldnuts (5). Secure with two washers (6), screws (7), and four clamps (8). 12. 13. 14. Install cable assembly (2) on weldnut (9). Secure with two straps (10), screws (11), new lockwasher (12), and one new locknut (13). Install pin (14) on accelerator pedal assem- bly (15). Secure with washer (16) and new cotter pin (17). Install cable assembly (2) on pin (14). Secure with collar (18) and set screw (19). ADJUST 15. Loosen set screw (19). Push control cable assembly (2) handle full forward. 16. Place pedal assembly (15) in full closed throttle position (see your -10). Tighten set screw (19) in collar (18). FOLLOW-THROUGH STEPS front access door 1. Start engine (see your -10). Using the pedal 3. Close power plant (15), check that hand throttle operates (see your -10). properly. 4. Raise trim vane (see your –10). 2. Stop/shutdown engine (see your –10). 5. Install driver’s power plant access panel (see your -10). END OF TASK 23-43

Privacy Statement
Press Release
Contact