INSTALL - TM-9-2350-261-20-2

REPLACE TRACK TENSION ADJUSTER AND MOUNT - TM-9-2350-261-20-2_497

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
463

TM 9-2350-261-20-2 INSTALL 8. Install relief valve (1) and grease fitting (2) in track tension adjuster (3). N O T E Grease fitting and relief valve of track tension adjuster should be toward front of earner. Make sure grease fitting is pointing out. 9. Place track adjuster (3) on shaft of idler arm. 10. Install mount (4) in front of adjuster (3). Raise adjuster and mount. Align hole in mount with hole in hull for screw (5). 11. Install screw (5) in mount (4). Tighten until snug. 12. Rotate mount (4). Install two screws (6). N O T E When using torque wrench with torque wrench adapter, torque value must be corrected. Procedure for converting torque value is on page 2-30. 13. 14. 15. Tighten screw (5) and two screws (6) to 130-140 lb-ft (176-190 N·m) torque. Use torque wrench and adapter. Install washer (7) and screw (8) in shaft idler arm. Tighten screw to 130–140 lb-ft (176-190 N·m) torque. Use torque wrench. Install washer (9) and screw ( 10) on mount (4). Tighten screw to 130-140 lb-ft (176-190 N·m) torque. Use torque wrench. FOLLOW-THROUGH STEPS 1. Connect and adjust track (see your –10). 3. Road test earner (page 2-45) to check that adjuster is installed properly. 2. Install track shroud and covers (page 22-2). END OF TASK 22-25

Privacy Statement
Press Release
Contact