REPLACE TRACK TENSION ADJUSTER AND MOUNT

CLEAN, INSPECT, AND REPLACE - TM-9-2350-261-20-2_496

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
462

TM 9-2350-261-20-2 REPLACE TRACK TENSION ADJUSTER AND MOUNT. DESCRIPTION This task covers: Remove (page 22-24). Clean, Inspect, and Replace (page 22-24). Install (page 22-25). INITIAL SETUP Tools: References General Mechanics Tool Kit (Item 30, App D) Torque Wrench Adapter (Item 8, App D) See your -10 Torque Wrench (Item 96, App D) Equipment conditions Personnel Required: Unit Mechanic Carrier on level surface Engine stopped/shutdown (see your -10) Carrier blocked (see your -10) Track shroud and covers removed (page 22-2) Track disconnected (see your -10) R E M O V E 1. 2. 3. 4. 5. 6. Remove screw (1) end washer (2) from mount (3). Remove screw (4) and washer (5) from shaft on idler arm. Pull track adjuster (8) down. Remove mount (3) from adjuster. Remove adjuster (8) from shaft on idler arm. Remove grease fitting (9) and relief valve (10) from adjuster (8). Remove two screws (6) from mount (3). Loosen screw (7). Rotate mount and remove screw (7). CLEAN, INSPECT, AND REPLACE 7. Check fittings end relief valve for wear and damage. Replace if needed. 22-24 Change 4

Privacy Statement
Press Release
Contact