REMOVE - TM-9-2350-261-20-2

R E P L A C E R E A R M A I N W I R I N G H A R N E S S ( M 1 1 3 A 2 , M 9 0 1 A 1 , A ND M 1 0 5 9 O N L Y)

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
269

T M 7. 8. 9. 10. 11. 9-2350-261-20-2 Disconnect circuit 451 lead (1) from rear 12. bilge pump (2). Disconnect circuit 21, 22, 23, and 24 leads 13. (3, 4, 5, and 6) from trailer tiring harness (7). Remove two screws (8), clamps (9), washers 14. ( 10), circuit 90 lead (11), and wiring har- ness (12) from two weldnuts (13). 15. Remove screw (14), clamp (15), bilge tube clamp (16), and wiring harness (17) from weldnut (18). 16, Remove two screws (19), nuts (20), and clamp (21 ) from floor transverse beam (22). Remove screw (23), nut (24), and clamp (21) from circuit 451 lead (25). Remove screw (26), Iockwasher (27), clamp (28), and circuit 451 lead (25) from weld. nut (29). Discard lockwasher. Remove two cradle clips (30) and circuit 451 lead (25) from two cradles (31). If personnei heater is installed, disconnect circuit 402 lead (32) from personnel heater fuel pump (33). If engine coolant heater is installed, discon- nect circuit 402A lead (34) from engine cool- ant heater fuel pump (35). 12-120

Privacy Statement
Press Release
Contact