TM 9-2350-261-20-2
6.
7.
8.
9.
10.
Remove six terminals (l), insulators (2), and
connectors (3) from six leads disconnected in
steps 1 through 5. Discard terminals.
Remove tape from leads 17 and 18
(4 and 5).
Remove bushing (6), retainer (7), and spring
washer (8), from coupling (9).
Remove four nuts (10), lockwashers (11),
washers (12), and two washers (13) from
hull bushing (14). Discard lockwashers.
Remove three cradle clips (15) and har-
ness (16) from three cradles (17).
Remove two screws (18), two clamps (19),
and harness (16) from weldnut (20).
CLEAN, INSPECT, AND REPAIR
11.
12.
13.
Check leads for continuity. Use multimeter.
Check harness for damage. Repair damaged
terminals (page 14-3).
Check for damaged connectors, if connectors
are damaged, turn into direct support
maintenance.
INSTALL
N O T E
New harness assembly comes with hull
bushing assemblies installed.
14.
15.
16.
Connect right headlight wiring harness (16)
to front main wiring harness (21) at drivers
compartment bulkhead.
Install clamp (19) on harness ( 16). Secure
clamp to hull weldnut (20) with screw (18).
Install harness (16) on three cradles (17).
Secure with three cradle clips (15).
12-80