TM 9-2350-261-20-2
R E P L A C E R E A R D O M E L I G H T L E A D ( M 7 4 1 A 1 O N L Y)
I N I T I A L S E T UP
Tools:
References:
General Mechanics Tool Kit (Item 30, App D)
see your -10
Marterials/Parts:
Equipment Conditions:
Tape (Item 26, App C)
Engine stopped/shutdown (see your -10)
Carrier blocked (see your -10)
Personnel Required:
Battery ground lead disconnected (page 13-2)
Unit Mechanic
R E M O V E
I N S T A LL
1.
2.
3.
Remove tape that holds circuit 38 lead (1) to 4.
adjacent electrical leads.
Disconnect lead (1) from rear of dome light
(2) and rear main wiring harness (3).
Pull lead (1) from five support brackets (4).
Remove lead from carrier.
5.
6.
Route circuit 38 lead (1) through five support
brackets (4).
Connect lead (1) to rear main wiring harness
(3) and rear dome light (2).
Connect lead (1) to adjacent electrical leads
with tape, use three one-half overlapping
turns at 7-8 inch (18-20 cm) intervals.
F O L L O W - T H R O U G H S T E PS
1. Connect battery ground lead (page 13-2)
3. Turn au switches OFF (see your -10).
2. Turn MASTER SWITCH ON. Operate rear
dome light to check that light operates
properly.
END OF TASK
12-63
