TM 9-2350-261-20-2
REPLACE WARNING PANEL LIGHTS
DESCRIPTION
This task covers:
Remove (page 11-22).
Clean, Inspect, Repair (page 11-23 ).
Install (page 11-23).
INITIAL SETUP
Tools:
References:
General Mechanics Tool Kit (Item 31, App D)
See your -10
Materials/Parts:
Equipment Conditions:
Light bulbs, as needed
Engine stopped/shutdown
Lockwasher (2)
Carrier blocked (see your
Personnel Required:
Unit Mechanic
(see your –10)
-10)
REMOVE
NOTE
There are four lights on warning light
panel. Remove all lights the same way.
1. Remove light bulb (1).
a. Turn lens (2) to the left. Remove lens and
gasket (3) from light assembly (4).
b. Push in and turn light bulb (1) to the left
and remove bulb from light assembly (4).
2. Remove light assembly (4).
NOTE
Do not disconnect more than one light at
a time. Mark each lead to make sure you
reconnect to correct contacts. See wiring
diagram (FO-2).
a. Disconnect circuit lead (5) from light as-
sembly (4).
b. Remove two screws (6), lockwashers (7),
and light assembly (4) from warning
lights panel. Discard lockwashers.
11-22
