REPLACE HORN SWITCH

CLEAN, INSPECT, AND REPAIR - TM-9-2350-261-20-2_157

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
127

TM 9-2350-261-20-2 REPLACE HORN SWITCH INITIAL SETUP Tools: References: General Mechanics Tool Kit (Item 30, App D) See your–10 Personnel Required: Equipment conditions: Unit Mechanic Engine stopped/shutdown (see your -10) Carrier blocked (see your -10) NOTE Two nuts and lockwashers come with new switch. REMOVE 1. 2. 3. 4. Disconnect circuit 25/25A connector (1) from rear of horn switch (2). Remove nut (3) and horn switch (2) from warning light panel. Remove suspension lockout light bracket (4) from horn switch (2) (M741A1 only). Remove lockwasher (5) and nut (6) from horn switch (2). Discard Iockwasher, INSTALL 5. 6, 7. Install nut (6) and new lockwasher (5) on horn switch (2). Install bracket (4) on horn switch (2) (M741A1 only). Install horn switch through rear of warning light panel. Secure with nut (3). 8. Connect circuit 25/25A connector (1) to rear of horn switch (2). FOLLOW-THROUGH STEPS 1. Turn MASTER SWITCH ON (see your -10). 3. Turn MASTER SWITCH OFF (see your –10). 2. Press horn switch to check for proper installa- tion. 11-24 END OF TASK

Privacy Statement
Press Release
Contact