install - TM-9-2350-261-20-2

R E P L A C E T A C H O M E T E R C A B L E A N D A D A P T E R

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
118

8. 9. Place adapter (1) on engine adapter, and secure with nut. Coat flexible drive shaft (2) with grease and install in cable (3) (see your –LO). N O T E Install keyed end of drive shaft (2) in tachometer end of cable (3). If cable (3) is being replaced, remove all clamps and install them on new cable. 10. Pull drive shaft (2) part way out of adapter end of cable (3), install slotted washer (4) and flat washer (5), on shaft. 11. Install new grommet (6) on cable (3). Route cable through power plant and driver’s compartment. 12. Install new gasket (7) on tachometer (8) and adapter ( 1). TM 9-2350-261-20-2 in cable. Install cable right angle drive N O T E Place cable at tachometer connection as close to carrier wall as possible to minimize bend. All other cables and leads should be in front of the tachometer cable. 13. 14, Align clamp (9) with clamp (10), and secure with screw (11) and new locknut (12). Align seven cable clamps (13) with power plant and driver’s compartment bulkhead weldnuts. Secure with seven new lockwashers (14) and screws (15). FOLLOW-THROUGH STEPS 1. Install power plant rear access panel 4. (page 24-27 or 24-29). 2. Install driver’s power plant access panel (page 24-25). 5. 3. Close power plant front access door and raise trim vane (see your -10). Start engine to check for proper installation of tachometer cable and adapter (see your -10). Stop/shutdown engine (see your -10). END OF TASK 11-15 I N S T A L L

Privacy Statement
Press Release
Contact