CLEAN, INSPECT, AND REPAIR - TM-9-2350-261-20-2

R E P L A C E M A S T E R S W I T C H T O D I S T R I B U T I O N B O X W I RE A S S E M B L Y ( C I R C U I T 4 9 L E A D )

C H A P T E R 10 S T A R T E R S Y S T E M M A I N T E N A N C E

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
96

TM 9-2350-261-20-2 CLEAN, INSPECT, AND REPAIR 5. Check circuit 49 lead for continuity. Use multimeter. Replace bad lead. INSTALL 6. 7. Install two new grommets (2) on circuit 49 lead (l). Route circuit 49 lead (1) through dristribution box (4) and master switch panel (3). Install new grommets (2) in box and panel. 8. 9. 10. Install circuit 49 lead (1) on bus bar (5) of distribution box (4). Secure with new lockwasher (6) and screw Install circuit 49 lead (1) terminal (8). Secure with new locknut (10). (7). on master switch washer (9), and Install master switch panel (3) on distribution box (4). Secure with eight screws (11), washers (12), and new locknuts (13). FOLLOW-THROUGH STEPS 1. Connect battery ground lead (page 13-2). 3. Check that circuit 49 lead is operational. MASTER SWITCH light should come on. 2. Turn MASTER SWITCH ON (see your -10). 4. Turn MASTER SWITCH OFF (see your-10). END OF TASK 9-50

Privacy Statement
Press Release
Contact